Skip to content
Collingwood Lock ExpertsRequest a visit
Open 24/7(249) 486-8066Call now
Hands using a power driver at the end of a horizontal push bar on an open metal door. — Panic & Exit Hardware, Collingwood

Plan ahead Commercial · Collingwood

Panic & Exit Hardware

Two doors used to swing as a pair at the community hall entrance, but one leaf has started closing before the other, catching the astragal and leaving a gap wide enough to worry the caretaker.

Call now · open 24/7(249) 486-8066

Request a visit

In plain words

Which device goes on a door depends on what the door already is. A single interior door usually takes a rim exit device and a simple pull or lever outside. Listed fire-exit hardware covers many tall, narrow-stile and fire-rated openings too, so a mortise or vertical-rod device is chosen for its latching arrangement or the door's own preparation, not from height or fire rating alone, and a fire-rated opening can never be held open by a mechanical dogging function. Reading the door correctly before ordering hardware is most of the job; fitting it well is the rest.

Sound familiar?

The new access-control reader at the staff entrance works fine going in, but nobody has sorted out the door's exit side, and right now a card reader and a pushbar exist as two separate ideas.

How the visit goes

Panic & Exit Hardware · Collingwood

How the visit goes

Technician holding a small key fob at a bench with a key-cutting machine, loose keys, and a motorcycle and scooter behind.
  1. 1

    Reading the door itself

    Every opening gets the same close look: whether it is fire-rated, which way it swings, how wide it is, and what preparation, if any, already exists in the door and frame from earlier hardware. A hollow-metal fire door takes a different device than a wood door in a non-rated partition, and a narrow-stile aluminum storefront door narrows the choice of device further still. Reading this correctly before anything is ordered is what keeps the installation from turning into a second visit once the wrong device arrives and does not fit the preparation already in the door.

  2. 2

    Choosing the device for the opening

    With the assessment done, the locksmith matches a device family to the door: a rim exit device for most single doors, a mortise device where a heavier-duty case suits the opening, or a vertical-rod device where latching is needed at both the top and bottom of the frame. Fire-rated openings take fire exit hardware specifically listed for that duty, never a standard panic device pressed into a role it was not built for, and listed rim fire-exit hardware covers a wide range of those openings on its own. The chosen device is matched to the door's width, handing and existing preparation before it is ordered.

  3. 3

    A door that opens under one motion, every time

    What the space has afterward is straightforward: anyone inside can leave through that door with a single push on the crossbar or touchpad, no key, no second step, no need to remember which way a lock turns. Staff can be shown the motion once and it stays intuitive, because that is exactly what the hardware is built to do. Outside, entry still works the way it was set up to, through the trim chosen for that door, entirely separate from the exit function inside.

In the van

  • Door closer
  • Signage and labels
  • Coordinator for door pairs
  • Rated exit device
  • Outside trim (pull, lever or cylinder)

What affects the quote

  1. 1

    Single door or a pair

    A pair of doors that needs ordered closing calls for a coordinator or an astragal, and one being converted into a single wide exit needs a mullion removed and replaced with vertical-rod devices on each leaf, both of which add work beyond a single-door installation.

  2. 2

    Number of keys or dogging cylinders

    Cutting keys for the outside trim and providing a dogging key or keyed dogging cylinder for the device is counted individually, the same way any keyed hardware is.

  3. 3

    Outside trim selected

    A plain pull is the simplest outside trim. A lever with a key cylinder, or a trim matched to other hardware finishes in the building, involves more parts and more fitting time.

Same fees day, night or weekend.

Have it ready

Before you call · 0 / 3

(249) 486-8066

Panic & Exit Hardware: questions

Advice · (249) 486-8066

How is occupant load actually counted for this decision?

Occupant load is calculated from the floor area and the intended use of the room, using published factors for that occupancy type, rather than a headcount taken on a busy night. A building official or a locksmith familiar with the calculation can work through it for a specific room, and the result is what decides whether the exit doors serving that room need a releasing device.

How much force does the door need to open with?

Hardware standards set a maximum, not a target: an exit device is built to release the latch under a firm push, no more than about 15 pounds of force applied at the touchpad or crossbar, roughly the pressure of a light shove rather than a heave. That ceiling covers people who cannot lean hard into a door, so the swing stays open to anyone moving toward it under pressure.

Is delayed-egress hardware allowed here?

Delayed-egress locking has a defined place in the codes that cover it, generally paired with sprinkler protection and a fire alarm system, and it is not a way to lock a door indefinitely; a short delay still releases on its own once the push is held, and always releases as soon as a fire alarm signal arrives. Whether it suits a given opening depends on the occupancy and the authority having jurisdiction, so it is confirmed with them before it is specified.

Simcoe, Ontario

Collingwood information

Town
Collingwood, Simcoe, Ontario
In business
25 years
Hours
Open 24/7 · nights, weekends and holidays, same fees
Visits
On-site assessment preferred. Request a visit or call.

What the census means at the door

40%

Homes of every age. About 40% of homes in Collingwood were built in 1980 or earlier, according to the 2021 Census.

Older frames and newer frames fail in different ways. Settled wood pulls strikes out of line; new framing settles as it dries. A locksmith used to a mixed area recognises which he is looking at and adjusts accordingly.

56%

A mix of homes. Single-detached houses make up about 56% of homes in Collingwood (2021 Census).

In an area with both houses and attached homes, the work varies by the door. A detached house wants all its exterior doors on one key; a suite door wants a cylinder that suits a metal frame and respects building rules. A locksmith carries parts for both.

Source: Statistics Canada, 2021 Census of Population

Open Collingwood in Google Maps

Open 24/7

Request a visit

Two doors used to swing as a pair at the community hall entrance, but one leaf has started closing before the other, catching the astragal and leaving a gap wide enough to worry the caretaker.

Call now · open 24/7(249) 486-8066
  • On-site assessment preferred
  • Same fees day, night or weekend
  • 25 years in business